KLEVV CRAS C910 1000GB

SSD Description

The KLEVV CRAS C910 is a mid-range PCIe 4.0 NVMe SSD built around the DRAM-less Inogrit IG5220 controller. Instead of dedicated SDRAM, it relies on Host Memory Buffer (HMB) to let the controller use a portion of system RAM for mapping table management. The controller is typically paired with 3D TLC NAND, allowing the drive to saturate mid-tier Gen4 bandwidth and prioritizing burst performance and power efficiency over sustained heavy-workload throughput. Analysis of the IG5220 shows it is thermally efficient compared to higher-end Gen4 controllers (such as the IG5236), resulting in minimal thermal throttling during standard consumer workloads. The drive ships with an extremely thin, pre-attached aluminum heatsink whose low profile helps compatibility with tight laptop chassis and PlayStation 5 expansion slots, though it relies heavily on system airflow. KLEVV is a brand of Essencore (an SK Group subsidiary), and component sourcing for this tier can vary, with NAND manufacturers rotating between batches while maintaining stated performance targets.

Key Specifications

• Interface: PCIe 4.0 x4, NVMe 1.4
• Controller: Inogrit IG5220 (RainierQ)
• NAND Flash: 3D TLC
• DRAM Cache: No (HMB Architecture)
• Sequential Read/Write: 5000 MB/s / 4800 MB/s
• Endurance (TBW): Rated at 700 TBW (1TB model)
• PCB Layout: Single-sided M.2 2280

Hardware Alternatives

• ADATA XPG Atom 50 & Patriot P400: Direct hardware clones using the same Inogrit IG5220 controller and HMB configuration, offering virtually identical performance behaviors.
• HP FX900: Close relative using the IG5220, sharing the same 5000 MB/s read ceiling and thermal characteristics.
• Crucial P3 Plus: Uses a Phison E21T controller and QLC NAND, targeting the same entry-to-mid Gen4 performance bracket; the C910’s use of TLC NAND generally offers superior write endurance and sustained performance compared to QLC alternatives.